I had this same problem with my last migration but this time I won't let it slow me down. Always check full system save job log to make sure the save finished with no errors otherwise it will give you trouble during the upgrade.
Message ID CPF3285
Message - Damage found on file QAYPSYSTEM in library QMGTC.
I don't know what causes but problem but glad there is a fix so I can move on.
 |
|
Problem Summary:
This document describes how to recover from a damaged QAYPSYSTEM file in library QMGTC.
Here are some of the error messages found regarding this issue:
CPF3285 - Damage found on file QAYPSYSTEM in library QMGTC, was received during a system weekly and daily backups.
CPF8111 - &8 damage on member &9 file &4. This message was found after a power failure .
Resolution:
The QAYPSGRPCT, QAYPSYSGRP, and QAYPSYSTEM files in the QMGTC library need to be re-created or restored from backup. If these files are re-created, the system group constraints, the endpoint system list, and the group system list will be deleted. Therefore, whenever it is possible, restore the files from backup.
Note: Due to file constraints, the three files need to be all re-created, or all restored from backup.
Do the following to delete and re-create the files:
| 1. | On the operating system command line, type the following:
ENDTCPSVR *MGTC , and press the enter key.
|
| 2. | Delete the file QAYPSGRPCT in library QMGTC as follows:
On the operating system command line, type the following:
DLTF FILE(QMGTC/QAYPSGRPCT) RMVCST(*REMOVE) , and press the enter key.
|
| 3. | Delete the file QAYPSYSGRP in library QMGTC as follows:
On the operating system command line, type the following:
DLTF FILE(QMGTC/QAYPSYSGRP) RMVCST(*REMOVE) , and press the enter key.
|
| 4. | Delete the file QAYPSYSTEM in library QMGTC as follows:
On the operating system command line, type the following:
DLTF FILE(QMGTC/QAYPSYSTEM) RMVCST(*REMOVE) , and press the enter key.
|
| 5. | On the operating system command line, type the following:
For V5R3:
CALL QSYS/QYPSSETUP PARM(V5R3M0)
For V5R4:
CALL QSYS/QYPSSETUP PARM(V5R4M0)
For V6R1:
CALL QSYS/QYPSSETUP PARM(V6R1M0)
Press the enter key.
For V7R1:
CALL QSYS/QYPSSETUP PARM(V7R1M0)
Press the enter key.
|
| 6. | On the operating system command line, type the following:
STRTCPSVR *MGTC , and press the enter key.
|
Note: This process does not prevent the file(s) from getting damage again. If the problem with the damage object recurs, you should contact IBM Support.
|
No comments:
Post a Comment